Wissenschaftlicher Artikel
Filtern
Erscheinungsjahr
- 2014 (30) (entfernen)
Dokumenttyp
- Wissenschaftlicher Artikel (30) (entfernen)
Schlagworte
- 360 degree Feedback (1)
- Assessment Center (1)
- Carboxylate (1)
- Case-Study (1)
- Eigentum (1)
- Evidence-based Management (1)
- Geldpolitik (1)
- Insolvenzeröffnung (1)
- Insolvenzplan (1)
- Insolvenzrecht (1)
Institut
The adsorption and reaction of the amino acid glycine (NH2-CH2-COOH) are studied experimentally on the polar single crystal surface of zinc oxide, ZnO(000-1), by X-ray photoelectron spectroscopy (XPS) under UV light in presence and absence of molecular O2. Deposition at 350 K mainly resulted in a largely deprotonatedmonolayer (NH2-CH2-COO−(a)+OH(s); where O is surface oxygen,(a)is for adsorbed and(s)is for surface species) identified by its XPS C1s binding energy at 289.3 eV (-COO), 286.7 eV (-CH2-) and XPS O1s at 531.8 eV(-COO). A decrease in the signals of all functional groups of the adsorbed glycine (monitored by their C1s, O1s,and N1s lines) is seen upon UV excitation in the absence and presence of O2pressures up to 5 × 10−6 mbar. The photoreaction cross sections extracted from the decrease in the C1s peaks were found to be =2.6 × 10−18(COO(a)) and 1.4 × 10−18(-CH2-)cm^2. The photoactivity of the ZnO(000-1) surface under UHV-conditions is found to be comparable to that seen in direct photolysis of amino acids in solution.
To achieve high temperature stable insulation materials for the electrical insulation of fine copper wires two different bis(alkoxysilylalkyl)pyromellitamide acids 1 and 2 were prepared. These organic–inorganic sol–gel hybrid precursors were obtained via reactions of pyromellitic dianhydride and alkoxysilylalkylamines. The molecular single-source precursors 1 and 2 were comprehensively studied using FT-IR, 1H, 13C and 29Si NMR spectroscopy as well as elemental analyses. Besides, the hydrolysis and condensation processes of the different precursors were examined with solution 29Si NMR spectroscopy. The imidization process was investigated using 13C NMR spectroscopy, FT-IR spectroscopy as well as thermal analysis methods. The different precursors were applied to coat fine copper wires using an industrial coating device. The obtained coatings were cured at temperatures between 380 and 425 °C, and tested regarding thicknesses, number of pinholes, electrical breakdown voltage and elongation. FT-IR spectroscopy was used to determine the chemical structure and scanning electron microscopy to investigate the morphology of the coating materials. The obtained coatings showed very promising mechanical, thermal and electrical properties, i.e. highest breakdown voltage values well above 200 V/µm. They possess high flexibility without cracking and no pinholes or other defects were detected.